Mini Lathe Control Board PCB – how to connect cables

This article could be potentially helpful for somebody who disassembled mini lathe PCB and forgot how to connect the cables back. Whatever the reason was, I would like to upload few pictures showing how the cables are connected. I personally use a Vevor CJ18A Mini Lathe. The quality is very, very bad, however the lathe works somehow. One of the many issue was that the metal bits went under the cover where the control box is installed. the issue was that the control box was not protected inside with anything!!! I was actually surprised that my lathe survived already few weeks. When I spoke to my mate, who uses a very similar lathe, he said that on his lathe the PCB under the cover is protected with the additional box. So I decided to make a special extra cover and protect everything with a bit of silicon. Pictures below, order a bit random.

Leave a Reply

Your email address will not be published. Required fields are marked *

Change the CAPTCHA codeSpeak the CAPTCHA code

This site uses Akismet to reduce spam. Learn how your comment data is processed.